McQuay MWM Specifications download pdf (Page 14)

MWM-J_(ii) Application Information

Installation Guideline

Safety Precautions

WARNING

CAUTION

• Installation and maintenance should be performed

by qualiﬁ ed persons who are familiar with local code

and regulation, and experienced with this type of

appliance.

• All ﬁ eld wiring must be installed in accordance with the

national wiring regulation.

• Ensure that the rated voltage of the unit corresponds

to that of the name plate before commencing wiring

work according to the wiring diagram.

• The unit must be GROUNDED to prevent possible

hazard due to insulation failure.

• All electrical wiring must not touch the refrigerant

piping or any moving parts of the fan motors.

• Conﬁ rm that the unit has been switched OFF before

installing or servicing the unit.

• Disconnect from the main power supply before

servicing the air conditioner unit.

• DO NOT pull out the power cord when the power is

ON. This may cause serious electrical shocks which

may result in ﬁ re hazards.

• Keep the indoor and outdoor units, power cable and

transmission wiring, at least 1m from TVs and radios,

to prevent distorted pictures and static. {Depending on

the type and source of the electrical waves, static may

be heard even when more than 1m away}.

Please take note of the following important points

when installing.

• Do not install the unit where leakage of ﬂ ammable

gas may occur.

If gas leaks and accumulates around the unit, it

may cause ﬁ re ignition.

• Ensure that drainage piping is connected properly.

If the drainage piping is not connected properly,

it may cause water leakage which will dampen

the furniture.

• Do not overcharge the unit.

This unit is factory pre-charged. Overcharge will

cause over-current or damage to the compressor.

• Ensure that the unit’s panel is closed after service

or installation.

Unsecured panels will cause the unit to operate

noisily.

• Sharp edges and coil surfaces are potential

locations which may cause injury hazards. Avoid

from being in contact with these places.

• Before turning off the power supply, set the remote

controller’s ON/OFF switch to the “OFF” position

to prevent the nuisance tripping of the unit. If this is

not done, the unit’s fans will start turning automatically

when power resumes, posing a hazard to service

personnel or the user.

• Do not operate any heating apparatus too close to the

air conditioner unit. This may cause the plastic panel to

melt or deform as a result of the excessive heat.

• Ensure the color of wires of the outdoor unit and

the terminal markings are same to the indoors

respectively.

• IMPORTANT : DO NOT INSTALL OR USE THE

• AIR CONDITIONER UNIT IN A LAUNDRY ROOM.

• Do not use joined and twisted wires for incoming

power supply.

NOTICE

Disposal requirements

Your air conditioning product is marked with this symbol. This means that electrical and electronic products

shall not be mixed with unsorted household waste.

Do not try to dismantle the system yourself: the dismantling of the air conditioning system, treatment of

the refrigerant, of oil and of other parts must be done by a qualiﬁ ed installer in accordance with relevant

local and national legislation. Air conditioners must be treated at a specialized treatment facility for re-use,

recycling and recovery. By ensuring this product is disposed of correctly, you will help to prevent potential

negative consequences for the environment and human health. Please contact the installer or local authority

for more information.

Batteries must be removed from the remote controller and disposed of separately in accordance with relevant

local and national legislation.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 89 90

Comments to this Manuals

No comments

McQuay MWM Specifications Page 14

Comments to this Manuals

Related products and manuals for Split-system air conditioners McQuay MWM