McQuay MWM Specifications download pdf (Page 32)

3) INDOOR UNIT PREPARATION

• The refrigerant piping can be routed to the unit in 5

direction, by using the cut outs in the unit casing.

(See fig. 1)

• Carefully bend the pipes to the required position to

align with the hole. For right hand and rear side draw

out, hold the bottom of the piping and fix direction

before shaping it to the desired position (See fig. 2).

The condensation drain hose should be taped to the

pipes with vinyl tape. The electrical cable can also be

taped to the pipes.

4) MOUNTING INDOOR UNIT

Hook the indoor unit onto the upper portion of installation plate. (Engage the 2 hooks of rear top of the indoor unit with

the upper edge of the installation plate). Ensure the hooks are properly seated on the installation plate by moving in

left and right.

5) WATER DRAINAGE PIPING

The indoor drain pipe must be downward gradient for smooth drainage. Avoid situation as shown in figure

below.

fig. 2

WOODEN

FRAME WALL

REINFORCED CONCRETE BUILDING

NUT ANCHOR BOLT ANCHOR

• Fixing method:-

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 164 165

No comments

McQuay MWM Specifications Page 32