McQuay MWMV Specifications download pdf (Page 6)

Receiving and Storage

Upon receipt of the equipment, check carton for visible

damage. Make a notation on the shipper’s delivery

ticket before signing. If there is any evidence of rough

handling, the cartons should be opened at once to check

for concealed damage. If any damage is found, notify

the carrier within 48 hours to establish your claim, and

request their inspection and a report. The Warranty

Claims Department should then be contacted.

Do not stand or transport the machines on end. For

storing, each carton is marked with “up” arrows.

In the event that elevator transfer makes upended

positioning unavoidable, absolutely insure that the

machine is in the normal upright position for at least 24

hours before operating.

Temporary storage at the jobsite must be indoors,

completely sheltered from rain, snow, etc. High or

low temperatures naturally associated with weather

patterns will not harm the conditioners. Excessively high

temperatures of 140°F (60°C) may deteriorate certain

plastic materials and cause permanent damage. In

addition, the solid-state circuit boards may experience

operation problems.

Note: Care should be taken when handling this equipment.

Rough handling can create damage to internal electri-

cal and refrigeration components.

IMPORTANT

This product was carefully packed and thoroughly inspected

before leaving the factory. Responsibility for its safe delivery

was assumed by the carrier upon acceptance of the

shipment. Claims for loss or damage sustained in transit

must therefore be made upon the carrier as follows:

VISIBLE LOSS OR DAMAGE

Any external evidence of loss or damage must be noted

on the freight bill or carrier’s receipt, and signed by the

carrier’s agent. Failure to adequately describe such external

evidence of loss or damage may result in the carrier’s

refusal to honor a damage claim. The form required to le

such a claim will be supplied by the carrier.

CONCEALED LOSS OR DAMAGE

Concealed loss or damage means loss or damage which

does not become apparent until the product has been

unpacked. The contents may be damaged in transit due

to rough handling even though the carton may not show

external damages. When the damage is discovered upon

unpacking, make a written request for inspection by the

carrier’s agent within fteen (15) days of the delivery date

and le a claim with the carrier.

Pre-Installation

WARNING

The installer must determine and follow all applicable

codes and regulations. This equipment presents hazards

of electricity, rotating parts, sharp edges, heat and weight.

Failure to read and follow these instructions can result in

property damage, severe personal injury or death. This

equipment must be installed by experienced, trained

personnel only.

General:

Units must be installed in accordance with all applicable

codes.

To prevent damage, this equipment should not be

operated for supplementary heating and cooling during

the construction period.

Inspect the carton for any specic tagging numbers

indicated by Daikin per a request from the installing

contractor. At this time, the voltage, capacity and model

should be checked against the plans.

Check the unit size against the plans to be sure that the

unit will be installed in the correct location.

Units should be kept in shipping carton until installed.

At the time the unit is to be placed in its nal position

and only then should the carton be removed. Retain

the carton and cut away one side and bottom. Take the

remaining portion of the carton and place it over the unit.

This will insure the unit is protected from paint spotting,

dirt, dust and lint that can affect proper unit operation,

and will also prevent needless cleaning adding to

installation cost.

The installing contractor will nd it benecial to confer

with other contractors; i.e., plumbing, electrical, pipe

tters, etc., before installing any conditioners.

Remove the front panel by removing a screw on each

side of the cabinet at the subbase.

All piping and electrical wiring should be exible so that

vibrations are not transmitted to the building structure.

Ensure all electrical connections are in place and tight.

Locate the unit in an area that allows easy removal

or accessibility for service personnel to perform

maintenance and repair.

If units are placed on a concrete oor or other hard

surface, it is recommended that the oor be free from

all construction debris that may add to the operating

noise level of the unit. It is recommended that the unit

be placed on rubber matting to prevent distortion and/or

vibration.

IM 447-11 6 www.DaikinApplied.com

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

Comments to this Manuals

No comments

McQuay MWMV Specifications Page 6

Comments to this Manuals